L E d A “C” Hex E d n Extension Tubes install in seconds and make aiming a breeze n Choose rigid brass Extension Tubes to direct coolant straight to the cutting edge n Choose bendable copper Extension Tubes to direct coolant around obstructions n Cut tube to desired length to suit your application ExtensionTubes can be used in a wide variety of QPM nozzles DIMENSIONS IN MILLIMETERS PART NO. THREAD LENGTH INSIDE Pkg Configuration “E” “L” Dia. “d” Qty SBT09705 M3.5 X .6 30mm 2mm 5 SBT09710 M4 x .7 30mm 2mm 5 SBT09720 M5 x .8 40mm 3mm 5 SBT09730 M6 x 1.0 50mm 4mm 5 SBT09735 M7 x 1.0 55mm 5mm 5 SBT09740 M8 x 1.25 55mm 5.5mm 5 Brass ExtensionTubes are ideal for directing coolant straight to the cutting edges. Material: Hex Fitting: Brass Tube: Copper Solder: Lead-free Max Pressure: 500 PSI (33 bar) Maximum Operating Temperature: 300°F (150°C) Material: Brass Maximum Pressure: 500 PSI (33 bar) Max Operating Temperature: 300°F (150°C) Bendable ExtensionTubes allow coolant to be directed around obstructions such as floating tap holders (above) or insert clamps (below) DIMENSIONS IN INCHES(except as noted) PART NO. THREAD “C” Tubing Tubing Pkg Configuration “E” Hex Size “A” ID “d” Qty ET09805 M3.5 x .6 3/16" 1/8" .07" 5 ET09810 M4 x .7 3/16" 1/8" .07" 5 ET09820 M5 x .8 1/4" 3/16" .12" 5 ET09830 M6 x 1.0 1/4" 3/16" .12" 5 ET09835 M7 x 1.0 5/16" 1/4" .18" 5 ET09840 M8 x 1.25 5/16" 1/4" .18" 5 ET09845 M8 x .5 6mm 3/16" .12" 5 ET09850 M8 x .5 7mm 1/4" .18" 5 ET09855 M10 x .5 6mm 3/16" .12" 5 ET09860 M10 x .5 8mm 1/4" .18" 5 ET09865 M12 x .5 6mm 3/16" .12" 5 ET09870 M12 x .5 8mm 1/4" .18" 5 ET09875 M12 x .5 10mm 5/16" .25" 5 BENDABLE COPPER EXTENSION TUBES RIGID BRASS EXTENSION TUBES Ideal for Coromant Capto* toolholders *Coromant Capto is a registered trademark of Sandvik AB WE RESERVE THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE OR OBLIGATION. Extension Tubes BENDABLE COPPER EXTENSION TUBES RIGID BRASS EXTENSION TUBES 17